Showing results 1 to 20 of 20
Search took 0.00 seconds.
Search: Posts Made By: Gdog
Forum: Engines & props 17 October 2014, 07:03
Replies: 21
Views: 7,101
Posted By Gdog
Hi. Has anyone heard of Mavi Mare hydraulic...

Hi. Has anyone heard of Mavi Mare hydraulic steering or had any experience with them? Thanks
Forum: Engines & props 09 July 2013, 20:26
Replies: 8
Views: 7,053
Posted By Gdog
Hi I have bf130a . Some of these engines had...

Hi I have bf130a . Some of these engines had issues ie cracks in the block , cylinder head . Fuel system required up grading .was subject to recall by honda .
A search on the net will be help full...
Forum: Engines & props 26 June 2011, 20:46
Replies: 16
Views: 2,629
Posted By Gdog
Hi. I have a yam 80hp 4stroke. Worst case is...

Hi. I have a yam 80hp 4stroke. Worst case is 22lt an hour. If it was me I would be basing all my calculations on worst fuel consumption. That way you should always end up with fuel to spare upon...
Forum: Engines & props 19 June 2011, 05:36
Replies: 6
Views: 3,844
Posted By Gdog
Update

Hi

The gearbox is in with Honda. Not looking good. It looks like someone had been at the gearbox before. A part had been put in in correctly. Hope to get it back this Friday.
Forum: Engines & props 08 June 2011, 08:45
Replies: 6
Views: 3,844
Posted By Gdog
Hi Spartacus Thanks for that. From...

Hi Spartacus

Thanks for that.
From throttle to shift rod is working fine. With the gear casing off and the shift rod in place (in the gear casing) we can put it in forwards (by using the shift...
Forum: Engines & props 08 June 2011, 07:40
Replies: 6
Views: 3,844
Posted By Gdog
Hi. Thanks for that. As you can see from photos...

Hi. Thanks for that. As you can see from photos we have dropped the gear case from the rest of the leg. It looks like the shift slider is damaged where the shift rod sits.

Question - does the...
Forum: Engines & props 06 June 2011, 19:10
Replies: 6
Views: 3,844
Posted By Gdog
Stuck in forward

Hi

Just putting the boat in the water after overhauling the trim/tilt unit. The boat reversed of the trailer no problem. Went into forwards and reverse a few times while manoeuvring around slip....
Forum: Engines & props 14 May 2011, 07:46
Replies: 4
Views: 1,221
Posted By Gdog
Working fine now

Thanks for your suggestions. Now working freely.
Forum: Engines & props 08 April 2011, 16:56
Replies: 4
Views: 1,221
Posted By Gdog
Thanks

Hi

thanks for that. Do you think soaking it in a bucket of diesel would help?

cheers

G
Forum: Engines & props 08 April 2011, 06:55
Replies: 4
Views: 1,221
Posted By Gdog
Question re cable steering

Hi

Had to take off the tilt trim unit as the seals and rods are knackered. While doing this realised the steering is stuck.
As you can see from photo we have taken the section the cable goes...
Forum: RIBs wanted 17 December 2010, 16:08
Replies: 2
Views: 1,719
Posted By Gdog
might have one that suits

Hi Jorg

I am selling my rib - Delta 5.5m - 80hp Yamaha 4st - €11,950. I have moved up to a bigger size. you can see the details under ribs for sale.

any questions let me know.

cheers
...
Forum: Engines & props 08 November 2010, 05:44
Replies: 1
Views: 1,435
Posted By Gdog
Rmoving tilt & trim

Hi

I have a Honda bf130a 4st. The tilt trim unit needs overhaul. I have identified the parts that need replacing (o rings, rods are pitted so changing them so they don't damage the new o rings),...
Forum: Engines & props 28 September 2010, 08:01
Replies: 7
Views: 1,948
Posted By Gdog
Thanks for info folks. The atf did have water in...

Thanks for info folks. The atf did have water in it. We are going to replace all the seals and need to replace both piston rods (trim) as they have pitting.

Can anyone tell me if I need to...
Forum: RIBs & ribbing 27 September 2010, 22:38
Replies: 10
Views: 5,758
Posted By Gdog
Hi Just about to put my 5.5 up for sale. ...

Hi

Just about to put my 5.5 up for sale. Attached is picture. We have a Yammy 4 stroke 80hp. Fuel economy is great. Knew the boat when it had a mariner 115hp 2 stroke (too much power). ...
Forum: Engines & props 25 September 2010, 06:19
Replies: 7
Views: 1,948
Posted By Gdog
Thanks guys. The top of the trim rams is...

Thanks guys.

The top of the trim rams is leaking and the fluid looks reddish.

A Honda guy said that a 20 weight ATF could be used instead. Anyone know what that is?

So I can just use...
Forum: Engines & props 24 September 2010, 16:21
Replies: 7
Views: 1,948
Posted By Gdog
Automatic transmission fluid

Hi

I have recently gotten a 2002 Honda ob 130hp. The Tilt is giving a little bit of trouble and it looks like the fluid is low. A few questions -

what colour should the fluid be? From what I...
Forum: Electrics and electronics 17 September 2010, 06:23
Replies: 3
Views: 1,634
Posted By Gdog
Aerial. Stainless vs fibreglass

Hi. Need a new aerial for my rib it's mounted on top of a-frame.

Any experience or comments on stainless whip vs fibreglass aerials?

Thanks

G
Forum: Electrics and electronics 26 August 2010, 10:59
Replies: 11
Views: 2,877
Posted By Gdog
Fusion vs other

Hi

Am thinking of getting a fusion radio/iPod dock for rib. Was surprised at how bulky the unit is.
Anyone have any experience or thoughts radios/iPod docks?

Thanks
Forum: Electrics and electronics 26 August 2010, 10:55
Replies: 10
Views: 2,635
Posted By Gdog
I was leaning towards lowrance, but came across a...

I was leaning towards lowrance, but came across a US forum with talk about leaking screen/case on the hds units, but have not been able to find it again.

But I am heading to Southampton boatshow...
Forum: Electrics and electronics 26 August 2010, 10:13
Replies: 10
Views: 2,635
Posted By Gdog
Garmingpsmap vs lowrance

Hi, hal8 beat me to a post on this. And rather than start a new one I thought I would add my question to this one

I currently have lowrance colour chart plotter (can't remember model), about 3.6...
Showing results 1 to 20 of 20

 


All times are GMT. The time now is 20:48.


Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2024, vBulletin Solutions, Inc.