Go Back   RIBnet Forums > Search Forums
Reload this Page Search Results
Click Here to Login

Join RIBnet Today
Showing results 1 to 20 of 20
Search took 0.00 seconds. Search: Posts Made By: maz
Forum: Inflatable boats - SIBs and folding RIBs 15 January 2013, 11:34
Replies: 19
Views: 6,607
Posted By maz
That's the place. It's compacted gravel so wheels...

That's the place. It's compacted gravel so wheels are fine. At very low water it gets sticky but I'd just give it a miss for 2 hours either side of LT. It's used by local fishermen but I saw several...
Forum: Inflatable boats - SIBs and folding RIBs 14 January 2013, 22:50
Replies: 19
Views: 6,607
Posted By maz
Hi Fenlander, I went down at Low Tide and had a...

Hi Fenlander, I went down at Low Tide and had a scout about. The hard in Peter Clarkes boatyard is indeed the best spot. I enquired about launching from there and was told that as long as you don't...
Forum: Inflatable boats - SIBs and folding RIBs 08 January 2013, 07:33
Replies: 19
Views: 6,607
Posted By maz
I have launched from there before but parking is...

I have launched from there before but parking is a pain and ironically I have a fairly long drive to get there compared to WMersea; it's not far by boat though!
Forum: Inflatable boats - SIBs and folding RIBs 07 January 2013, 21:49
Replies: 19
Views: 6,607
Posted By maz
Oh Ok, thanks for the heads-up. I don't know it...

Oh Ok, thanks for the heads-up. I don't know it but I will have a look on the chart.
Forum: Inflatable boats - SIBs and folding RIBs 07 January 2013, 14:39
Replies: 19
Views: 6,607
Posted By maz
Do you mean the beach at Stone Point in East...

Do you mean the beach at Stone Point in East Mersea? If so then the problem is that you can't get a vehicle anywhere near it!
Forum: Inflatable boats - SIBs and folding RIBs 03 January 2013, 22:13
Replies: 16
Views: 3,011
Posted By maz
I forgot about Ribshop; I can vouch for them too....

I forgot about Ribshop; I can vouch for them too. Very good advice and service.
Forum: Inflatable boats - SIBs and folding RIBs 03 January 2013, 21:32
Replies: 16
Views: 3,011
Posted By maz
I had a 50p sized hole chewed in my SIB by mice...

I had a 50p sized hole chewed in my SIB by mice and after seeking advice on here I repaired it myself. It was pretty easy and the boat holds it's air perfectly well. My advice would be to take your...
Forum: Inflatable boats - SIBs and folding RIBs 01 January 2013, 22:09
Replies: 28
Views: 6,727
Posted By maz
My story is better anyway since the mouse got...

My story is better anyway since the mouse got killed and the boat got fixed. I don't want anyone to think I set it up by rubbing cheese on the side though.
Forum: Inflatable boats - SIBs and folding RIBs 01 January 2013, 12:41
Replies: 28
Views: 6,727
Posted By maz
A mouse chewed a hole in my Plastimo Raid270....

A mouse chewed a hole in my Plastimo Raid270. Completely unprovoked.
Forum: Inflatable boats - SIBs and folding RIBs 31 December 2012, 16:28
Replies: 19
Views: 6,607
Posted By maz
Thanks for the reply, I was talking about the T...

Thanks for the reply, I was talking about the T shaped pontoon area in general. So I guess the hard between the pontoon and the dabchicks sailing club would be best. I think I'll take a look at very...
Forum: Inflatable boats - SIBs and folding RIBs 31 December 2012, 13:20
Replies: 19
Views: 6,607
Posted By maz
Launching question West Mersea

Hi all, I need a bit of advice; how long either side of HT have I got (on an average tide) to launch and retrieve from the pontoon area at West Mersea? I have launched from Rowhedge area and fished...
Forum: Inflatable boats - SIBs and folding RIBs 29 July 2012, 14:59
Replies: 12
Views: 2,298
Posted By maz
I should point out that I hit 20 mph but full...

I should point out that I hit 20 mph but full speed was mostly 18-19mph. I'm man enough to admit I wouldn't fancy going much faster in that little boat.
Forum: Inflatable boats - SIBs and folding RIBs 29 July 2012, 13:53
Replies: 12
Views: 2,298
Posted By maz
This is the floor. Hope the photo attaches!...

This is the floor. Hope the photo attaches! Lightning, to be fair there was almost no wind and the water was like a mirror.
Forum: Inflatable boats - SIBs and folding RIBs 29 July 2012, 12:41
Replies: 12
Views: 2,298
Posted By maz
Good point but it's rated to take a 10HP. I dread...

Good point but it's rated to take a 10HP. I dread to think how fast that would go. I was surprised at how fast it went with a 5. Maybe I'm just being a bit of a wuss!
Forum: Inflatable boats - SIBs and folding RIBs 29 July 2012, 12:26
Replies: 12
Views: 2,298
Posted By maz
I should have said that; it only seems to happen...

I should have said that; it only seems to happen at full speed.
Forum: Inflatable boats - SIBs and folding RIBs 29 July 2012, 12:16
Replies: 12
Views: 2,298
Posted By maz
No it's not an inflatable floor. It is just flat...

No it's not an inflatable floor. It is just flat PVC with 3 boards.
Forum: Inflatable boats - SIBs and folding RIBs 29 July 2012, 12:02
Replies: 12
Views: 2,298
Posted By maz
Newbie Question...

Having repaired the mouse hole and fully serviced the engine I took my SIB out on the estuary last night to test all is well. I'm pretty happy with everything but when I gave it the full beans on the...
Forum: Inflatable boats - SIBs and folding RIBs 26 July 2012, 17:14
Replies: 5
Views: 1,609
Posted By maz
4 mice in 3 days; I'm surprised I've got a boat...

4 mice in 3 days; I'm surprised I've got a boat left!
Forum: Inflatable boats - SIBs and folding RIBs 24 July 2012, 13:56
Replies: 5
Views: 1,609
Posted By maz
Thanks for the advice guys; the patch is now...

Thanks for the advice guys; the patch is now applied and I will have to wait 24 hours to test it's effectiveness. I will take your tip and have also invested in an emergency repair kit. That is a...
Forum: Inflatable boats - SIBs and folding RIBs 23 July 2012, 22:00
Replies: 5
Views: 1,609
Posted By maz
Repair question

I took my SIB out of the garage today to check it over as I intend going out this weekend and I have found that mice have chewed a 20p sized hole in the top of one of the tubes. Now, I know that...
Showing results 1 to 20 of 20

 


All times are GMT. The time now is 08:51.

Contact Us - RIBnet - Archive - Community Rules - Terms of Service - Privacy - Accessibility - Top

Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2024, vBulletin Solutions, Inc.