Magnet glue for Mariner 60 flywheel

[Dankoozy]

I am after dislodging a couple of magnets while removing the flywheel off my Mariner so need to glue them back. I have seen Loctite 331 mentioned but would have to order from the States. Any alternative I should try?

[Dankoozy]

Nevermind I have it sorted Loctite AA 326 from RS Online + activator spray 7649 is what I ended up using.



Not the hardest job just spent a while cleaning the surface of the magnet and flywheel with sand paper then acetone. The glue is wicked fast to set so you literally only have a few seconds to put them in the right place. I 3d printed the little slither of plastic with the bit sticking out in the middle to help me place the magnet, not essential but it did help