Forum: RIBs & ribbing
17 April 2022, 19:12
|
Replies: 6
Views: 741
|
Forum: RIBs & ribbing
17 April 2022, 18:28
|
Replies: 6
Views: 741
|
Forum: RIBs & ribbing
17 April 2022, 17:40
|
Replies: 6
Views: 741
Lifejackets - How Old Is Too Old?
An acquaintance has a large number of NOS Challenger Interlock 275N auto twin-chamber lifejackets with integral crotchstraps still in original sealed, UV proof packages. However, they've not been...
|
Forum: Electrics and electronics
30 July 2021, 12:32
|
Replies: 6
Views: 875
I bought a new Salty John antenna with cable...
I bought a new Salty John antenna with cable attached. Pulled new cable through A-frame, trunking, under deck then into console. The supplied connection was fitted after trimming the cable and...
|
Forum: Engines & props
11 May 2021, 17:57
|
Replies: 6
Views: 1,216
|
Forum: Engines & props
11 May 2021, 17:51
|
Replies: 6
Views: 1,216
|
Forum: Engines & props
23 April 2021, 13:10
|
Replies: 6
Views: 1,216
Death Bolt
I was reading (scaring myself with) this thread:
https://www.thehulltruth.com/boating-forum/357798-check-your-steering-death-bolt.html
So, decided to check mine whilst sorting some steering...
|
Forum: Engines & props
20 April 2021, 12:53
|
Replies: 0
Views: 395
Anti-Siphon Valves on Fuel System
I'm about to change the fuel hoses on a Ribtec 655. The line from the tank to filter/separator is 3/8" and the line from the filter/separator is 5/16" including the break for the primer bulb which...
|
Forum: Engines & props
18 April 2021, 19:17
|
Replies: 0
Views: 745
Mercury Flush Connection 22-857175 Alternative
Wonder if this would be helpful, and hopefully searchable! I 'float tested' my connector - and it doesn't!
Tried to buy an OEM replacement but could only get one from the states at £50-odd. I...
|
Forum: Engines & props
10 April 2021, 12:31
|
Replies: 22
Views: 2,099
|
Forum: Engines & props
10 April 2021, 12:20
|
Replies: 22
Views: 2,099
|
Forum: Engines & props
10 April 2021, 09:12
|
Replies: 3
Views: 494
|
Forum: Engines & props
09 April 2021, 14:50
|
Replies: 3
Views: 494
|
Forum: Engines & props
09 April 2021, 14:46
|
Replies: 3
Views: 494
115 Opti Water Pump Change - bit left over!
Hi Guys, I dropped the lower leg off, replaced every part that cam in the water pump kit but can't seem to figure where the grey sleeve goes!
Any pointers, or is it not applicable to this 2005...
|
Forum: Bits and pieces
30 November 2019, 16:42
|
Replies: 4
Views: 1,573
|
Forum: Bits and pieces
20 November 2019, 12:15
|
Replies: 4
Views: 1,573
|
Forum: Engines & props
13 November 2019, 17:09
|
Replies: 324
Views: 494,911
|
Forum: Bits and pieces
13 November 2019, 17:00
|
Replies: 4
Views: 1,573
|
Forum: Bits and pieces
13 November 2019, 09:41
|
Replies: 4
Views: 1,573
Mercury Laser II 20P Stainless Prop
Part no. 48-16990-20P Stainless prop in nice condition with little to no rough edges. Tried for a few runs but over-propped for my 115 Opti!
Does £175 including postage sound right?
...
|
Forum: RIBs & ribbing
21 September 2019, 19:59
|
Replies: 7
Views: 906
|
Forum: RIBs & ribbing
21 September 2019, 19:59
|
Replies: 7
Views: 906
|
Forum: RIBs & ribbing
20 September 2019, 10:03
|
Replies: 7
Views: 906
|
Forum: RIBs & ribbing
20 September 2019, 09:38
|
Replies: 7
Views: 906
Hull Drain Solutions - Inline Pump??
Looking for some input from the experts, if you guys don’t mind!
With my Ribtec I have the bilge ‘well’ at the aft end with a submersible bilge pump and the obligatory elephants trunk. ...
|
Forum: RIBs & ribbing
11 July 2019, 18:03
|
Replies: 18
Views: 1,725
|
Forum: RIBs & ribbing
11 July 2019, 14:29
|
Replies: 18
Views: 1,725
|