Forum: Electrics and electronics
13 October 2015, 17:45
|
Replies: 8
Views: 1,549
|
Forum: Electrics and electronics
11 October 2015, 20:48
|
Replies: 8
Views: 1,549
Thanks. I've been trying that this afternoon -...
Thanks. I've been trying that this afternoon - problem is that it all checks out, resistances/voltage on the supply to the starboard engne and those for the port side are the same, except that the...
|
Forum: Electrics and electronics
11 October 2015, 08:19
|
Replies: 8
Views: 1,549
Mysterious short circuit
Ideas wanted please - what's going on here? I seem to have a major short circuit in the electrics around the A-frame and engines but can't work out how its happening.
The boat has twin 50hp...
|
Forum: RIBs & ribbing
21 April 2015, 19:06
|
Replies: 9
Views: 1,187
Well I've been using this stuff for about three...
Well I've been using this stuff for about three years now on a pair of Mariner two-strokes and they've been fine so far. And when I got it first time I rang the manufacturer, they sent me a copy of...
|
Forum: RIBs & ribbing
22 September 2014, 20:13
|
Replies: 17
Views: 4,902
Have used a few in Kent:
- Gillingham Pier, as...
Have used a few in Kent:
- Gillingham Pier, as above, easy to use but tide limited ( our first trip in our rib was from here, took advice from the old boy collecting the money when we needed to be...
|
Forum: Electrics and electronics
09 September 2014, 23:25
|
Replies: 7
Views: 2,069
|
Forum: RIBs & ribbing
07 August 2014, 23:25
|
Replies: 21
Views: 3,615
We were in the Scillies a few years back on a...
We were in the Scillies a few years back on a charter yacht when a rib pulls alongside and the occupant announces himself as an off- duty policeman, flashed some id we never did get to see properly...
|
Forum: RIBs & ribbing
02 July 2014, 23:24
|
Replies: 16
Views: 1,794
|
Forum: RIBs & ribbing
13 June 2014, 07:15
|
Replies: 16
Views: 1,794
|
Forum: RIBs & ribbing
12 June 2014, 07:06
|
Replies: 16
Views: 1,794
|
Forum: RIBs & ribbing
12 June 2014, 06:29
|
Replies: 16
Views: 1,794
Round Britain in a sailing dinghy
Hi Ribnetters,
Those of you in Northern Ireland now, Scotland over the next couple of weeks, and down the East coast after that, please keep an eye out for these guys - one of whom is someone I've...
|
Forum: RIBs & ribbing
10 June 2014, 00:07
|
Replies: 82
Views: 10,561
The hot weather brings out the prats in all...
The hot weather brings out the prats in all areas. Driving back from the coast on Sunday the 150 mile a year bikers were out in force in the South Downs. Overtaking at speed on blind bends and brows,...
|
Forum: RIBs & ribbing
30 April 2014, 20:25
|
Replies: 16
Views: 2,077
|
Forum: Engines & props
30 April 2014, 20:13
|
Replies: 2
Views: 1,053
Well, i'd understood that within the unit there...
Well, i'd understood that within the unit there are actually two relays, one up and one down, so the problem was likely an issue with the down relay (as when I reversed the wires to the motor it was...
|
Forum: Engines & props
29 April 2014, 19:44
|
Replies: 2
Views: 1,053
Mariner tilt relay
Hi
I suspect the relay for the tilt/trim motor on my Mariner 50 2-stroke (3 cylinder, circa 1993) may be on the way out ( as soon as the battery gets a bit low, the tilt will go up but not down;...
|
Forum: Electrics and electronics
29 April 2014, 00:44
|
Replies: 4
Views: 1,250
I have gone down the route of a simple extra...
I have gone down the route of a simple extra breaker switch (one of those with a red plastic l-shaped key not expensive) for anchor light and auto bilge pump, as the only things I'd be likely to want...
|
Forum: Electrics and electronics
12 April 2014, 19:44
|
Replies: 5
Views: 18,999
|
Forum: Electrics and electronics
12 April 2014, 19:32
|
Replies: 5
Views: 18,999
|
Forum: Electrics and electronics
05 April 2014, 13:43
|
Replies: 9
Views: 1,374
|
Forum: Engines & props
13 March 2014, 21:06
|
Replies: 17
Views: 2,763
|
Forum: Bits and pieces
09 March 2014, 22:55
|
Replies: 8
Views: 924
|
Forum: Engines & props
03 March 2014, 00:00
|
Replies: 1
Views: 1,116
|
Forum: RIBs & ribbing
15 February 2014, 07:59
|
Replies: 3
Views: 927
I just had my seats recovered (by a place that...
I just had my seats recovered (by a place that mainly does motorcycle seats and clothing repairs) and although they used a suitable vinyl, they recommended car leather cleaner for looking after them...
|
Forum: Other stuff
28 October 2013, 04:16
|
Replies: 88
Views: 11,798
|
Forum: Engines & props
19 October 2013, 07:22
|
Replies: 40
Views: 9,003
|