seat pic request

[gtflash]

looking for some pics of bolster, bucket seats or even jockeys in various stages of build, from mould inc foam padding and triming etc! need ideas for an ongoing project!

thanks alot gt

[iandl]

GT ...I know you asked but i had a look for pictures of my build on the bolsters but they've all gone along with my pc .....been transfering files all weekend and sifting through them i cant find any other than finished ones .....i am making some Ullman replicas but dont want to show incase of liabilities etc I'm away to portugal tomorrow and i'll pm you some pics if you fancy.
The lower pod is made ....just getting ready to take a mold off it .......these are the shocks that i'm putting on
http://cgi.ebay.com/ebaymotors/ws/eB...152660665&rd=1

I have the stainless in cad drawing ready to be cut via waterjet, 3mm thick 316 stainless ....I havent made the top seat part as yet ...will start that when i return
the carbon fibre plates are from here
http://www.carbonology.com/carbon-fibre-sheet-c-2.html


they will get upholstered to blend in with my bolsters
I

[gtflash]

any pics greatly appreciated! shame about the bolster pics!! I would be curious to know how much padding the fabric and sponge added or intruded into the seat area??

[iandl]

GT ...the seats overall are 1150mm wide ....the centre is 125mm (150mm with foam)with the ends 100mm(125mm with foam) ....there is 1/2 thick foam all round except the inner back ...i found this picture from the upholsterer ...doesnt help much though.

I

[Ullman]

Originally Posted by iandl

GT ...I know you asked but i had a look for pictures of my build on the bolsters but they've all gone along with my pc .....been transfering files all weekend and sifting through them i cant find any other than finished ones .....i am making some Ullman replicas but dont want to show incase of liabilities etc I'm away to portugal tomorrow and i'll pm you some pics if you fancy.
The lower pod is made ....just getting ready to take a mold off it .......these are the shocks that i'm putting on
http://cgi.ebay.com/ebaymotors/ws/eB...152660665&rd=1

I have the stainless in cad drawing ready to be cut via waterjet, 3mm thick 316 stainless ....I havent made the top seat part as yet ...will start that when i return
the carbon fibre plates are from here
http://www.carbonology.com/carbon-fibre-sheet-c-2.html


they will get upholstered to blend in with my bolsters
I