deck paint

[tom russell]

need advice on some deck paint, which one will i need to but for painting the deck of my sr4 in grey also for the back of my transom in grey. Also is there anyway i can tidy up the hull painted in orange, some peeling paint and scratches? what filler would i need ect, thanks guys...

[jeffstevens763@g]

hi tom

did my rib floor with flow coat containing grit non slip but you can get it without grit, i ordered my stuff from east coast resins [Newcastle] really helpful there.

regards jeff

[tom russell]

Originally Posted by jeffstevens763@g

hi tom

did my rib floor with flow coat containing grit non slip but you can get it without grit, i ordered my stuff from east coast resins [Newcastle] really helpful there.

regards jeff

wicked thanks mate

[camelgas]

sand off all the old paint first or the flow coat will not stick properly .

[jeffstevens763@g]

tom

took mine down to the original glass-fiber with a 60 grit disc on a 4 inch grinder bit dusty but keep cleaning up as you go, then cleaned the whole lot with acetone, mask off, brush apply flow coat,pull masking tape off before coating sets.i found it easier with the tubes flat and a piece of plywood between the tubes and the grinder just in case i slipped same round consul/seats.

regards jeff

[tom russell]

thanks guys for all this help