Reply
 
Thread Tools Search this Thread
 
Old 06 August 2014, 09:49   #51
Member
 
paddlers's Avatar
 
Country: UK - England
Town: Sticks, N.Yorks
Boat name: Tamanco
Make: Honwave 3.5AE
Length: 3m +
Engine: Tohatsu Outboard
Join Date: May 2012
Posts: 1,063
On the ones I've seen a short (10 to 20 mm)short male pipe protrudes up from the top of the housing containing a rubber washer .Over this slips a guide approximately 80cm long (plastic) that enables you to locate the downpipe when refitting the gearbox.

On the ones I've done there's nothing on the end of the downpipe !!
__________________

__________________
paddlers is offline   Reply With Quote
Old 06 August 2014, 10:21   #52
Member
 
Country: UK - England
Boat name: ....
Length: no boat
Engine: Mercury 15hp
Join Date: Feb 2013
Posts: 96
The rubber piece looks to be attched to a length of rubber hose which is then onto a length of copper pipe ? not sure if its copper but it is metal ! the pipe is pretty loose.. it can rotate too, not sure if it should be or not !

I started a new thread on this impeller thing to make it easier for anyone to follow rather than trail through "water in lower leg " thread !

Merc 15 2st Impeller Fitting
__________________

__________________
HighlandR is offline   Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off





Copyright 2002- Social Knowledge, LLC All Rights Reserved.

All times are GMT -5. The time now is 06:02.


Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2017, vBulletin Solutions, Inc.