Showing results 1 to 25 of 693
Search took 0.03 seconds.
Search: Posts Made By: Jelly
Forum: RIBs & ribbing 19 December 2012, 06:52
Replies: 14
Views: 3,606
Posted By Jelly
Basically they are too tall and the supports in...

Basically they are too tall and the supports in the wrong direction, we stopped using them to tow after this mainly used for attaching buoys and tying up. The posts on the full time mark boats were...
Forum: RIBs & ribbing 13 December 2012, 10:07
Replies: 14
Views: 3,606
Posted By Jelly
Good luck with your purchase, please be careful...

Good luck with your purchase, please be careful with the tow post.
This was a tow about 30deg from due astern on one of the 5.85 we used during the olympics to get a snagged anchor up. We had...
Forum: RIBs & ribbing 08 September 2010, 03:42
Replies: 2
Views: 3,005
Posted By Jelly
Star Brite whip-it dip-it Thinners

I tried to use my old pot of whip it yesterday and it had gone a bit gloopy, talked to the manufacturers and was told to use Acetone to thin it down.
I was also told that it was that same stuff as...
Forum: RIBs & ribbing 08 September 2010, 03:35
Replies: 22
Views: 6,072
Posted By Jelly
Greetings Willk Glad to hear she is being used,...

Greetings Willk
Glad to hear she is being used, she wasn't down here with me, I find myself doing race mark laying / safety these days and she was too big for that.
Pity to see her gone she's a...
Forum: RIBs & ribbing 08 September 2010, 02:46
Replies: 22
Views: 6,072
Posted By Jelly
safety boats

Greetings
the VSR is a very maneuverable boat, but rather light and subject to getting blown about a bit. The RYA designed console is good though, its good for coaching and judge work.
I'd get a...
Forum: Other stuff 10 February 2010, 04:01
Replies: 2
Views: 1,436
Posted By Jelly
A story I heard and its only a story is that MCA...

A story I heard and its only a story is that MCA doesn't want any boats left, but that would make it the only emergency service without one, even the RSPCA have them.
Don't get me wrong I like the...
Forum: Other stuff 28 January 2010, 05:51
Replies: 13
Views: 2,290
Posted By Jelly
Then again you never know with Labs, my old one...

Then again you never know with Labs, my old one we were never sure if she would lick the burglar to death or eat it
...
Forum: Engines & props 16 December 2009, 05:28
Replies: 29
Views: 4,361
Posted By Jelly
HI Stu Grafham water used to have I think 4...

HI Stu
Grafham water used to have I think 4 5.4m seariders with Honda four stokes I think 50 or 60's. They were alright weren't going to set your hair on fire but you don't want that on a club...
Forum: RIBs & ribbing 05 November 2009, 09:58
Replies: 10
Views: 3,141
Posted By Jelly
submersible Rib

Sharpness Shipyard builds a submersible RIB
https://www.maritimejournal.com/archive101/2009/november/ship__and__boat_building/underwater_maintenance_ribb_is_a_diving_duck
Forum: Bits and pieces 15 September 2009, 11:02
Replies: 1
Views: 1,045
Posted By Jelly
Daniel I have a HM-134B available that I got to...

Daniel
I have a HM-134B available that I got to fit my 601 but never fitted, I'm open to offers if that will do what you want?
PM me
Rgds
James
Forum: RIBs reported stolen 17 August 2009, 09:16
Replies: 1
Views: 2,282
Posted By Jelly
The outboard was SN number 65WL1025670 blue...

The outboard was SN number 65WL1025670
blue Yamaha F25A model
it had lock nuts but they were removed, the gentleman responsible has been caught but refuses to say who he sold it to in fear of...
Forum: RIBs reported stolen 10 August 2009, 11:43
Replies: 1
Views: 2,282
Posted By Jelly
Yamaha 4stroke 25hp Handsteer - Plymouth

Plymouth Youth Sailing has had one of it's 25HP Yamaha 4 stroke hand steer outboards stolen over the weekend.
The Hand Steer on the 25HP 4St is a special order item so quite rare.
Taken from Mt...
Forum: RIBs & ribbing 17 June 2009, 09:51
Replies: 22
Views: 40,664
Posted By Jelly
I had a similar issue and posted solution on a...

I had a similar issue and posted solution on a previous thread. Basically put the hub puller on it tightening it up and good doses of WD40 or other penetration oil, over a period of a few days with...
Forum: Engines & props 11 June 2009, 03:52
Replies: 12
Views: 3,712
Posted By Jelly
Hi Dave thanks for the link, looks like they...

Hi Dave
thanks for the link, looks like they only sell cylinder seal kits for some units and not helm.
Many thanks
James
Forum: Engines & props 11 June 2009, 02:52
Replies: 12
Views: 3,712
Posted By Jelly
Apologies for thread creap, but can you strip and...

Apologies for thread creap, but can you strip and replace the seals etc on the seastar/baystar units if you did need to?
I was warned that one manufacturer you couldn't. I did it on my Lecomb &...
Forum: RIBs & ribbing 09 June 2009, 12:21
Replies: 16
Views: 2,730
Posted By Jelly
Tim good on you for finding a source, is it UV...

Tim
good on you for finding a source, is it UV and fuel proof?
Just wondering for when I get onto the next project!
Rgds
James
Forum: Other stuff 18 May 2009, 04:00
Replies: 18
Views: 5,686
Posted By Jelly
Typhoon WOOS suits are great, if only they had a...

Typhoon WOOS suits are great, if only they had a hood like the musto ocean one, that would be nice .....
Forum: Tow vehicles, 4x4s, trucks, cars & bikes 13 May 2009, 03:16
Replies: 20
Views: 3,713
Posted By Jelly
Matt I remember seeing a TV program that was a...

Matt
I remember seeing a TV program that was a mechanical version of time team and they did either an M1 or 2 up in the REME workshops. All was fine till someone decided to test the seals luckily...
Forum: RIBs & ribbing 27 April 2009, 03:55
Replies: 5
Views: 1,091
Posted By Jelly
Stu If it fail just add the vodka:thumbs: ...

Stu
If it fail just add the vodka:thumbs:
Jelly
Forum: Other stuff 24 April 2009, 03:32
Replies: 6
Views: 1,697
Posted By Jelly
Thank you guys, now sorted James

Thank you guys, now sorted
James
Forum: Electrics and electronics 22 April 2009, 04:33
Replies: 2
Views: 1,595
Posted By Jelly
Chewy Merc/mariner make an external kill cord...

Chewy
Merc/mariner make an external kill cord switch for dashboard mounting all wired up, with instructions on how to enter it into the loom. About 20 I think but that was a few years back, I...
Forum: RIBs & ribbing 21 April 2009, 12:03
Replies: 15
Views: 2,659
Posted By Jelly
Gemca I will try to answer some of your...

Gemca
I will try to answer some of your questions, you don't need a license to own or operate a boat used for pleasure in the UK but its highly recommended to do some formal training in fact a...
Forum: Other stuff 21 April 2009, 10:19
Replies: 6
Views: 1,697
Posted By Jelly
James ...

James
https://www.rya.org.uk/assets/racing/racemanagement/Web%20Documents/Race%20Officials%20Scheme/Race%20Official%20Application%20Form%2006-05-08.pdf

If you can that would be great
Rgds
James
Forum: Other stuff 21 April 2009, 07:30
Replies: 6
Views: 1,697
Posted By Jelly
The RYA's new forms aren't playing nicely like...

The RYA's new forms aren't playing nicely like that :-(
Forum: Other stuff 21 April 2009, 04:49
Replies: 6
Views: 1,697
Posted By Jelly
Any ideas on software to fill in a PDF form?

Now that people keep issuing forms in PDF but can't be bothered to make them so you can fill them in on a computer and expect you to print it off and fill in by hand.
Has anyone found a safe...
Showing results 1 to 25 of 693

 


All times are GMT -5. The time now is 05:01.


Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2021, vBulletin Solutions, Inc.