RIBnet Forums - Search Results

		RIBnet Forums > Search Forums
Search Results

Showing results 1 to 3 of 3
Search took 0.00 seconds. Search: Posts Made By: beamishken

Forum: RIBs & ribbing

09 June 2020, 08:02

Replies: 12

Rib to transom repair

Views: 4,179

Posted By beamishken

If you read the origional post its been repaired...

If you read the origional post its been repaired with epoxy, which is going to be difficult if not impossible to remove without abrasion. If it was original glue then I'd agree however its not normal...

Forum: RIBs & ribbing

08 June 2020, 07:35

Replies: 12

Rib to transom repair

Views: 4,179

Posted By beamishken

Carefull sanding is probably the only way to get...

Carefull sanding is probably the only way to get built up adhesive off then finish with solvent.
The 2 pack glue is applied to both surfaces & is contact adhesive so initial bond is immediate...

Forum: RIBs & ribbing

07 June 2020, 18:28

Replies: 12

Rib to transom repair

Views: 4,179

Posted By beamishken

Get it cleaned up then glued then inflate the...

Get it cleaned up then glued then inflate the tubes whilst holding them clear of the prepared glue. Once fully inflated roll the tube into the final contact position. Once the glue has 'grabbed'...

Showing results 1 to 3 of 3

All times are GMT. The time now is 00:45.