RIBnet Forums - Search Results

		RIBnet Forums > Search Forums
Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: Dirk Diggler

Forum: RIBs & ribbing

05 November 2009, 10:38

Replies: 31

Right then boys this is the big one… Transom build time.

Views: 5,081

Posted By Dirk Diggler

I'm not suggesting that the transom should be a...

I'm not suggesting that the transom should be a total of 36mm, just the wood that's in it. Assuming the outer laminates are being used (see above post) then a couple of csm's to bed the first 18mm...

Forum: RIBs & ribbing

05 November 2009, 10:33

Replies: 31

Right then boys this is the big one… Transom build time.

Views: 5,081

Posted By Dirk Diggler

I wasn't aware that he was removing the whole...

I wasn't aware that he was removing the whole transom, I assumed he was leaving the main lay up, and just replacing the Wood and overlaminates.

As for vacuuming, I expect that's a bit too...

Forum: RIBs & ribbing

05 November 2009, 09:28

Replies: 31

Right then boys this is the big one… Transom build time.

Views: 5,081

Posted By Dirk Diggler

That'd look excellent, but a smooth gel coat...

That'd look excellent, but a smooth gel coat inner transom isn't the best surface to laminate knees to. :]

Forum: RIBs & ribbing

05 November 2009, 08:19

Replies: 31

Right then boys this is the big one… Transom build time.

Views: 5,081

Posted By Dirk Diggler

That's an unusually thick transom for a little...

That's an unusually thick transom for a little boat, 2 x 18 mm is the norm. any thicker and you may run into problems with steering clearance/motor fit.

I'd make them to midway between the...

Showing results 1 to 4 of 4

All times are GMT. The time now is 12:24.