RIBnet Forums - Search Results

		RIBnet Forums > Search Forums
Search Results

Showing results 1 to 6 of 6
Search took 0.00 seconds. Search: Posts Made By: chewy

Forum: Engines & props

02 September 2009, 15:12

Replies: 11

Mercury clamshell iginition/timing

Views: 2,602

Posted By chewy

Cheers mate, the front of the airbox is off and i...

Cheers mate, the front of the airbox is off and i saw the crap run out then run down my transom and burn the paint off! I didn't undo the bolt that drain the float bowls so this is my next job. If...

Forum: Engines & props

02 September 2009, 13:53

Replies: 11

Mercury clamshell iginition/timing

Views: 2,602

Posted By chewy

Forgot to say it just dies no loud bang or...

Forgot to say it just dies no loud bang or anything spectacular.

I looked at taking the carbs off but if I do that engine will never run again, too many small fiddly bits for me.

The carb...

Forum: Engines & props

02 September 2009, 13:15

Replies: 11

Mercury clamshell iginition/timing

Views: 2,602

Posted By chewy

Blasted carb cleaner through from the fuel bowl...

Blasted carb cleaner through from the fuel bowl and a bit of shite came through. Its had new control cables and everything appears ok, I greased it all when I put it back together.

Will have a...

Forum: Engines & props

02 September 2009, 09:38

Replies: 11

Mercury clamshell iginition/timing

Views: 2,602

Posted By chewy

It runs at tickover and in gear but once to 50%...

It runs at tickover and in gear but once to 50% throttle in gear it cuts out. It restarts fine and revs freely in neutral.
It did for half an hour run through half throttle to WOT but after that it...

Forum: Engines & props

02 September 2009, 05:37

Replies: 11

Mercury clamshell iginition/timing

Views: 2,602

Posted By chewy

It might as well be rocket science as I haven't a...

It might as well be rocket science as I haven't a clue about stuff like that.
I had a look on iboats but couldn't see anything?
Mines premix and does smoke a little.

Forum: Engines & props

01 September 2009, 13:28

Replies: 11

Mercury clamshell iginition/timing

Views: 2,602

Posted By chewy

Mercury clamshell iginition/timing

Seen as the useless gits who were meant to fix my engine couldn't be @rsed its back to the drawing board.

Just spoke to a lad who said the timing or iginition (can't remember which) may need...

Showing results 1 to 6 of 6

All times are GMT. The time now is 11:16.