We previously had to replace the connectors that link our FF250C transducer cable to the power/data cable as the factory-fitted connectors had become corroded. We now need to replace the connectors again but cannot find the information on how to match the wires within the two cables - and as the wires had totally corroded off their pins inside the connector we can't just look at the current arrangement to find out
[We're aware that cutting the cables is not recommended but as the original connectors had failed we had no choice - and we've had a couple of years trouble-free use since doing so].
Has anyone got information on what the wires in each of the cables are for so we can match them up? The wires concerned are:
Transducer cable [
https://buy.garmin.com/shop/shop.do?pID=748] (plastic transom-mount, depth & temperature, part number 010-10272-00) - 5 wires:
Black
White
Red
Green
Bare
Power/data cable [
https://buy.garmin.com/shop/shop.do?pID=579] (18-pin, part number 010-10145-00) transducer lead - 6 wires:
Black
White
Red
Brown
Blue
Bare
I'm guessing it's a long shot but if we can't get this info we need to replace both bits with new! Thanks.
Karl (University of Sussex Sub-Aqua Club)
