Outdrive problem - Pacific 22

pacific 22 · 22 May 2006, 15:27

The pic attached is of happier days when my outdrive hydraulics worked.

Does anyone know where to get parts, I need a hydraulic pump, a 90 degree watertight through bulkhead fitting and a set of 4 flexible hoses for under the rear deck.

I would also like to know where to get outdrive parts.

jamie · 22 May 2006, 15:44

Sorry to say but lancing marine are the uk dealer for stern powr i hah the same fitting go. For a little stainless it cost £ 75 uou would thought they were gold.
Regards Jamie.

Pete7 · 22 May 2006, 15:50

As Jamie says if you have a credit card then Lancing Marine if your in a hurry, but they do carry spares. Alternatively we think Mermaid bought lots of spares from Stan in Plymouth so they could be worth a try, however the best bet would be the yellow pages and a local hydraulics firm, take the old ones in and ask them to make up a new set of hoses. The pump is about £600 from Lancing but have seen a similar one in our local Portsmouth hydraulics firm for about £125 although it was only 12 volts and someone has a Mercruiser unit on there stern drive, so some options about.

http://www.mermaid-marine.co.uk/

http://www.lancingmarine.com/

how did that lot go all at the same time ?

Pete

Scary Des · 22 May 2006, 17:11

try these ebay shops

got what you need and with the dollar as it is they look very well priced

Des

http://stores.ebay.com/RUDDYMART

http://stores.ebay.com/SEAQWEST-1

Scary Des · 22 May 2006, 17:30

Just checked the price for the pump and including delivery it is £200 cheaper than Lancing

Rip off Britain

Cue Codders

Ken · 12 June 2006, 14:13

I have used this guy ( http://stores.ebay.com/RUDDYMART ) before and the service was excellent.

I am just about to order some more parts from him for my sternpowr 101.
UJ bellows & cowl, output shaft seal etc. Even with the carriage and if you end up paying VAT on the import he's cheaper.

Ordered some anodes in Feb and they turned up in 4 days from the usA!

When I ordered a manual from Lancing it took 3 weeks and i had to chase twice!!

Paul F · 12 June 2006, 21:36

We have a mercruiser unit on ours running off of 12volts.
Paul

Nos4r2 · 12 June 2006, 22:00

Is that the same as the old merc outboard remote hydraulic trim/tilt pump?

Paul F · 14 June 2006, 20:10

No its the type fitted to the Mercuiser/ alpha leg. with intgeral oil res fitted under the motor.
Paul

Nos4r2 · 15 June 2006, 20:08

Fair enough- I had a reconditioned 12v remote trim/tilt pump from the old external trim/til system from the 70's here when I posted that but sold it 2 days ago.