Forum: Engines & props
12 July 2009, 17:38
|
|
Replies: 18
Views: 9,505
|
|
Forum: Engines & props
11 July 2009, 21:53
|
|
Replies: 18
Views: 9,505
KKKKKKKK YEEEEEEEEEEEESSSSSSSSS
exaust gasket...
KKKKKKKK YEEEEEEEEEEEESSSSSSSSS
exaust gasket changed (both inner and outer) ran it on a HEAVY oil load to be on the safish side and it ran
Mix some decent fuel tommorrow and put a new pull cord...
|
|
Forum: Engines & props
11 July 2009, 14:32
|
|
Replies: 18
Views: 9,505
fair no i didnt take offence at the manual bit...
fair no i didnt take offence at the manual bit its just that before i shell out 45 notes on a manual i was wondering if any one had any ideas or had come across it before.
Have tested the piss pipe...
|
|
Forum: Engines & props
11 July 2009, 07:47
|
|
Replies: 18
Views: 9,505
4 stokes not a problem but two strokes are a...
4 stokes not a problem but two strokes are a different kettle of fish. its not a case of not having the ability to fix it more of where the parts are and the terminolgy used to describe the areas (...
|
|
Forum: Engines & props
11 July 2009, 07:26
|
|
Replies: 18
Views: 9,505
when i say completly flooded it wasnt full of...
when i say completly flooded it wasnt full of water but enough to cut her out
Pistons seem to look ok rings seem to be ok and the crown of the piston although a bit coked not too bad (from what i...
|
|
Forum: Engines & props
11 July 2009, 07:15
|
|
Replies: 18
Views: 9,505
k i just been given the old INNER cover plate...
k i just been given the old INNER cover plate that covers that old hole and its in a pretty bad way. corroded away. the new one is good the outer plate is in good condition but the gasket between...
|
|
Forum: Engines & props
11 July 2009, 06:33
|
|
Replies: 18
Views: 9,505
mmmm bear with me here cos i know NOTHING about...
mmmm bear with me here cos i know NOTHING about these things
it appears to be both .. when i take the side cover plate that the (I think is the throttle ccable) attatched to both pistons look wet....
|
|
Forum: Engines & props
11 July 2009, 05:32
|
|
Replies: 18
Views: 9,505
|
|
Forum: Engines & props
10 July 2009, 21:51
|
|
Replies: 18
Views: 9,505
|
|
Forum: Engines & props
10 July 2009, 20:18
|
|
Replies: 18
Views: 9,505
Mercury 200 20 hp
Aquired cheap mercury 200 20hp today but it has a small problem.
The impeller has been changed no problem engine runs fine( on muffs) BUT when you imerse it and cool from the pump then the bore...
|
