RIBnet Forums - Search Results

		RIBnet Forums > Search Forums
Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: doggypaddle

Forum: Engines & props

10 June 2013, 20:29

Replies: 9

Chrysler 4.5hp 1970's flywheel issue

Views: 2,302

Posted By doggypaddle

Ram a tap down em;)

Ram a tap down em;)

Forum: Engines & props

10 June 2013, 19:17

Replies: 9

Chrysler 4.5hp 1970's flywheel issue

Views: 2,302

Posted By doggypaddle

so what are the 3 holes at 120 degree spacing...

so what are the 3 holes at 120 degree spacing around the centre bolt then?

are they not threaded?

I would be very cautious with a 3 legged puller on the flywheel periphery, you may get half the...

Forum: Engines & props

10 June 2013, 14:45

Replies: 9

Chrysler 4.5hp 1970's flywheel issue

Views: 2,302

Posted By doggypaddle

Should have mentioned that, I assumed that a non...

Should have mentioned that, I assumed that a non hydraulic puller was being used on the UNC holes.
I suppose you can whack a hydraulic puller but it would prolly feck it up!!

Forum: Engines & props

10 June 2013, 12:24

Replies: 9

Chrysler 4.5hp 1970's flywheel issue

Views: 2,302

Posted By doggypaddle

Replace "bit of pressure" with a "lot of...

Replace "bit of pressure" with a "lot of pressure" , and "a tap" with "a big sharp whallop" from a copper hammer straight on top of the puller. Leave the nut on or it may take your teeth out as it...

Showing results 1 to 4 of 4

All times are GMT. The time now is 04:57.