Go Back   RIBnet Forums > Search Forums
Reload this Page Search Results
Click Here to Login

Join RIBnet Today
Page 1 of 2 1 2
Showing results 1 to 25 of 27
Search took 0.00 seconds. Search: Posts Made By: Tris
Forum: Engines & props 08 May 2014, 21:47
Replies: 1
Views: 2,429
Posted By Tris
Suzuki df140 manual/ torque settings needed

Can anyone help. I'm after power head torque settings.
Thanks.
Forum: Engines & props 23 March 2014, 22:15
Replies: 10
Views: 2,310
Posted By Tris
Exactly. It's like an mot for your boat as it's...

Exactly. It's like an mot for your boat as it's probably the only time it gets checked. Would you mot your car and feel safe
Forum: Engines & props 23 March 2014, 21:50
Replies: 10
Views: 2,310
Posted By Tris
It's a good idea to general maintenance your...

It's a good idea to general maintenance your self. It's also beneficial to have a trained technician do the service. They are aware of things to look for to prevent future failures. A service is not...
Forum: Engines & props 23 March 2014, 13:01
Replies: 1
Views: 1,136
Posted By Tris
New? Give me a shout or email. Dry Sailing...

New? Give me a shout or email.
Dry Sailing (https://drysailing.co.uk)
Forum: Engines & props 23 March 2014, 12:59
Replies: 10
Views: 2,310
Posted By Tris
Plugs, oil, oil filter, water separator filter,...

Plugs, oil, oil filter, water separator filter, impeller and gasket. Gear lube probably £80
Labour 3 hours. In my case £30 plus vat.
Forum: Engines & props 23 March 2014, 12:53
Replies: 5
Views: 4,669
Posted By Tris
IV done lots of these. Common fault. Remove the...

IV done lots of these. Common fault. Remove the power head and clean up. Replace with fresh gasket and grease.
Forum: RIBs reported stolen 23 March 2014, 12:44
Replies: 21
Views: 6,743
Posted By Tris
I will put the poster in our office at Cowes Dry...

I will put the poster in our office at Cowes Dry Sailing centre cowes. Will also keep an eye open but as you also fear they are probably already off the Isle of Wight.
Forum: RIBs wanted 02 October 2013, 21:39
Replies: 6
Views: 2,182
Posted By Tris
5.5m 2006 X-S 75 evinrude etec. Full cover road...

5.5m 2006 X-S 75 evinrude etec. Full cover road trailer £14495?
tristan_orm@hotmail.com for more details.
Tristan.
Forum: Engines & props 16 May 2013, 19:39
Replies: 6
Views: 1,805
Posted By Tris
They were so bad they were hilarious. I hope...

They were so bad they were hilarious.
I hope retirement is treating you well. Every day is now Saturday.
I am well. I have bought the business I worked for which was part of Isle of Wight...
Forum: Engines & props 15 May 2013, 19:41
Replies: 6
Views: 1,805
Posted By Tris
Thanks. Your not the uncle al the yearly joke...

Thanks. Your not the uncle al the yearly joke teller? If you are it will make sense. If not then I just sound mad.
Forum: Engines & props 14 May 2013, 21:00
Replies: 6
Views: 1,805
Posted By Tris
Mariner 40 50 60 efi manual?

Is there any where on line that you can find the above workshop manual. I'm in need to various torque settings etc.

Thanks
Forum: Bits and pieces 18 June 2012, 14:42
Replies: 6
Views: 1,059
Posted By Tris
£200 delivered?

£200 delivered?
Forum: Bits and pieces 16 June 2012, 09:39
Replies: 6
Views: 1,059
Posted By Tris
Optimax 150 trim rams

As above. needed as the 2 damper rams end caps are fubard??

07590773966
Forum: Engines & props 13 June 2012, 19:20
Replies: 5
Views: 1,199
Posted By Tris
Stats checked today. All clean and open close...

Stats checked today. All clean and open close free. Will check filter. Thanks.
Forum: Engines & props 13 June 2012, 18:48
Replies: 5
Views: 1,199
Posted By Tris
Checked and double checked. Impeller can only go...

Checked and double checked. Impeller can only go one way. One side in its casting has a slot for key. The other is blanked. I am leaning towards sender to be honest. May take a look at replacing in...
Forum: Engines & props 13 June 2012, 17:52
Replies: 5
Views: 1,199
Posted By Tris
1000hr opti over heat alarm??

225opti done 1000 hours. Just serviced. All water pump inc housing wear plate etc good. Impeller new. poppet valve replaced last year.
At Tickover the smart craft gauge reads 0.6-0.8 bar block...
Forum: Engines & props 06 June 2012, 21:14
Replies: 4
Views: 1,229
Posted By Tris
When I do them I change the thin gasket under the...

When I do them I change the thin gasket under the waterpump housing 27-8172771 £3.60
I take the lower wear plate off and clean in there and change the lower gasket 27-430331 £3.63
and the face seal...
Forum: Engines & props 06 June 2012, 20:56
Replies: 12
Views: 7,677
Posted By Tris
Has it only leaked after you done oil change? did...

Has it only leaked after you done oil change? did you double check when you changed the oil filter that the o ring seal came away with the old filter?
I have seen them stay on the engine then when...
Forum: Engines & props 01 May 2012, 13:40
Replies: 6
Views: 3,396
Posted By Tris
indicates to carbs. bottom carb sounds like its...

indicates to carbs. bottom carb sounds like its flooding? is the plug wet when you take it out after a run.
usually if an ultrasonic bath does not cure a faulty carb it worthy of the bin. its a...
Forum: Engines & props 27 April 2012, 21:55
Replies: 19
Views: 3,292
Posted By Tris
whats the service/change (hours or years)...

whats the service/change (hours or years) intervals on the Iridium plugs
Forum: Engines & props 25 April 2012, 13:27
Replies: 11
Views: 2,564
Posted By Tris
should just unplug loom, follow 1 red 1 black and...

should just unplug loom, follow 1 red 1 black and disconnect them, disconnect fuel line unbolt and get strong
Forum: Engines & props 14 April 2012, 22:16
Replies: 5
Views: 1,269
Posted By Tris
If you dont mind the travel to the isle of wight....

If you dont mind the travel to the isle of wight. cowes drysailing centre next to east cowes marier 01983 282438
Forum: Engines & props 14 April 2012, 22:14
Replies: 12
Views: 5,790
Posted By Tris
Is it right you can use a few plugs to get them...

Is it right you can use a few plugs to get them to line up right? do you mark on the white on the plug where the open electrode is before inatlling
Forum: Engines & props 03 April 2012, 22:37
Replies: 10
Views: 1,936
Posted By Tris
I have heard of running a hotter plug. I worked...

I have heard of running a hotter plug. I worked on a 2stroke 115 IIRC and it would not produce full revs, spoke to an "outboard guru" and said, it should have these try these. and the thing ran like...
Forum: Engines & props 02 April 2012, 22:32
Replies: 14
Views: 21,183
Posted By Tris
timing belt number is VKMA05608 thats a southern...

timing belt number is VKMA05608 thats a southern exhaust number. 85plus VAT
as for the wastegate issues cookee mentioned they also have tendencies to go pop in RIBS and That sort of boat due to the...
Showing results 1 to 25 of 27
Page 1 of 2 1 2

 


All times are GMT. The time now is 00:28.

Contact Us - RIBnet - Archive - Community Rules - Terms of Service - Privacy - Accessibility - Top

Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2024, vBulletin Solutions, Inc.