Forum: Engines & props
14 November 2014, 06:53
|
Replies: 1
Views: 2,117
Hi, I'm no expert & also quite an outboard...
Hi, I'm no expert & also quite an outboard newbie, but I've been looking for a thermostat for my 2002 Yamaha 50hp 4 stroke outboard as the original is stuck open, what I've found is that there are...
|
Forum: Engines & props
12 November 2014, 10:58
|
Replies: 8
Views: 2,110
|
Forum: Engines & props
09 November 2014, 11:39
|
Replies: 8
Views: 2,110
|
Forum: Engines & props
09 November 2014, 09:04
|
Replies: 8
Views: 2,110
Yamaha 50hp running on flushing muffs
Yamaha 4 stroke 2002 50hp
When running on cooling muffs, I get water coming out of the tell tale hole at the top, which is correct... but also from a small hole at the back of the lower unit and...
|
Forum: Engines & props
04 November 2014, 20:12
|
Replies: 1
Views: 950
Yamaha question
Hi
Yamaha 50hp 4 stroke outboard 2002
Above the engine oil drain plug on the front of the engine, is a small round hole, and above this a small rectangular hole... what are these for ???
I...
|
Forum: Engines & props
03 November 2014, 21:45
|
Replies: 6
Views: 1,276
|
Forum: Engines & props
03 November 2014, 20:22
|
Replies: 6
Views: 1,276
|
Forum: Engines & props
03 November 2014, 17:01
|
Replies: 6
Views: 1,276
|
Forum: Engines & props
03 November 2014, 08:38
|
Replies: 6
Views: 1,276
Engine testing Yamaha 50hp 4 stroke
Hi all... so I constructed a test stand for my Yamaha 50HP outboard, connected up all the controls, rigged up a fuel tank from an lawnmower, battery etc... and after a bit of cranking it fired up....
|
Forum: Engines & props
28 October 2014, 16:24
|
Replies: 5
Views: 1,353
|
Forum: Engines & props
28 October 2014, 16:02
|
Replies: 5
Views: 1,353
Hi Jason, yeah that's pretty much what I have,...
Hi Jason, yeah that's pretty much what I have, but I've got some 3" castor wheels on each corner to push it around in my garage and out into the driveway when I run it up.
I'm going to mount the...
|
Forum: Engines & props
28 October 2014, 15:18
|
Replies: 5
Views: 1,353
Outboard Engine test stand
Hi all
I recently got my first boat, Mercury Quicksliver 530HD + Yamaha F50 4 stroke outboard.
I have the engine off the boat, and have built up a pretty substantial test stand from 4" X 2"...
|
Forum: Inflatable boats - SIBs and folding RIBs
05 September 2014, 15:52
|
Replies: 8
Views: 1,526
|
Forum: Inflatable boats - SIBs and folding RIBs
05 September 2014, 12:25
|
Replies: 8
Views: 1,526
|
Forum: Inflatable boats - SIBs and folding RIBs
05 September 2014, 12:04
|
Replies: 8
Views: 1,526
Simple SIB question
Hi all, sorry for what might seem a simple question.
Recently bought first ever boat- Quicksilver 530 XS HD SIB
it's been standing for a while so 've stripped it all down, took off the outboard...
|
Forum: Engines & props
19 August 2014, 20:36
|
Replies: 2
Views: 2,041
|
Forum: Engines & props
19 August 2014, 16:36
|
Replies: 2
Views: 2,041
Basic question Yamaha F50 AET
Hi all... RIB newbie here :-(
No previous experience with outboards, but lots of experience restoring motorbikes...nut & bolt up including engines, so not stupid either :-)
I've just bought a...
|
Forum: Say Hello | New Member Introductions
18 August 2014, 07:46
|
Replies: 1
Views: 679
New owner- Newcastle Under Lyme
Hi all
New owner here, never owned a boat before, well versed in motorbike restorations & mechanical/electronics etc etc
Just bought a 5.3M Quicksilver foldable RIB inc 50HP yamaha outboard,...
|