Forum: RIBs & ribbing
09 June 2004, 06:46
|
Replies: 3
Views: 1,390
Poor Fuel!
Noticed on my last trip that my top speed had reduced by about 8knts, the engine seemed fine, conditions were good. I wasnt till later that my wife was complaining that her car didnt seem to be...
|
Forum: Upcoming RIB cruises
01 June 2004, 18:18
|
Replies: 2
Views: 1,978
|
Forum: Electrics and electronics
17 May 2004, 04:42
|
Replies: 0
Views: 1,728
Mercury Tacho
Does ne1 know where i could pick up a reasonably priced tacho for a 1984 mercury 80hp?
Or does ne1 have one knocking about they wish to sell?
|
Forum: Electrics and electronics
10 May 2004, 11:19
|
Replies: 3
Views: 1,974
|
Forum: Electrics and electronics
09 May 2004, 09:10
|
Replies: 3
Views: 1,974
Mercury Tacho
I have a tacho which I am going to fit in the week, the only problem i have is that on the back there are 2 settings, 1 is for a 12pole alternator and the other is for a 10 pole alternator. The...
|
Forum: Engines & props
04 May 2004, 21:21
|
Replies: 22
Views: 6,478
Hydrofoils
Is there any real benefits of having these fitted to outboards, and what if any ar the disadvantages?
|
Forum: Electrics and electronics
01 May 2004, 21:49
|
Replies: 6
Views: 1,824
Waypoints
Anyone know of a good site for waypoints? or do i still have to do it the hard way........
|
Forum: Electrics and electronics
28 April 2004, 21:36
|
Replies: 5
Views: 1,977
GPS Speed
How accurate is the speed given on a GPS set in relation to actual speed?
|
Forum: Electrics and electronics
27 April 2004, 19:04
|
Replies: 3
Views: 2,569
Mercury Tachometer and Wiring Harness
I have an 84' Mercury 80hp and have been told that the socket on the opposite of the control box to where the key goes is to accomadate a wiring harness for a Tachometer. would anyone know where I...
|
Forum: RIBs & ribbing
20 April 2004, 14:31
|
Replies: 1
Views: 1,408
Boat Fishing
Does anyone know of any good Boat Fishing web sites.
|
Forum: Engines & props
10 April 2004, 19:51
|
Replies: 2
Views: 1,405
Mercury Power Trim
Could any body tell me if the fluid level should be checked when the engine is in the fully out position or should it be when the engine is dead against the transom?
Merc 80hp 84"
|
Forum: Engines & props
09 April 2004, 16:37
|
Replies: 2
Views: 1,804
Outboard Repair Manual
Could anyone tell me which workshop manuals are the best out of "Clymer" and "Seloc" or if you could point me in the direction of a better one for a 84" 80hp merc.
|
Forum: Engines & props
08 April 2004, 15:20
|
Replies: 3
Views: 1,819
|
Forum: Engines & props
08 April 2004, 14:53
|
Replies: 3
Views: 1,819
Outboard Fitting
When fitting an outboard should the engine be dead centre in relation the hull or (as has been suggested) that the engine should be off set?
Any halp appreciaited.
|
Forum: Engines & props
07 April 2004, 17:08
|
Replies: 5
Views: 1,602
|
Forum: Engines & props
07 April 2004, 16:07
|
Replies: 5
Views: 1,602
2 stroke outboard oil
Does anyone know of a website where you can purchase oil, or is this something that cannot be mailed?
|
Forum: Engines & props
05 April 2004, 20:41
|
Replies: 7
Views: 2,105
|
Forum: Engines & props
05 April 2004, 15:54
|
Replies: 7
Views: 2,105
Engine Transfers
hope this is in the right section, does anyone know if it is possible to get hold of a new set of transfers for an 84' Mercury 80hp, they are white with a blue stripe underneath. Any help appreciated.
|