Forum: RIBs & ribbing
05 November 2013, 15:45
|
Replies: 18
Views: 3,756
:thumbs:
Ian
As another...
:thumbs:
Ian
As another northerner, I am pleased to see that you just went "OUT".
Had you gone "OVER AND OUT" as was suggested you probably would have failed your course!
Anyhow- all...
|
Forum: Engines & props
05 November 2013, 15:42
|
Replies: 29
Views: 3,727
Trimix
Thanks for the engine numbers
I am...
Trimix
Thanks for the engine numbers
I am over at Coniston Water in the Lakes for the next few days at Powerboat Records Week (which we sponsor), doing some high-speed stuff (and probably...
|
Forum: Inflatable boats - SIBs and folding RIBs
05 November 2013, 14:16
|
Replies: 11
Views: 3,932
Dij66
To answer the original questions
1....
Dij66
To answer the original questions
1. New Zodiac speed tubes are normally available for Futuras, as new and genuine parts. However this assumes the boat is not too old that Zodiac have...
|
Forum: Inflatable boats - SIBs and folding RIBs
05 November 2013, 14:00
|
Replies: 9
Views: 3,308
The question you need to ask yourself is very...
The question you need to ask yourself is very simple - are you still insured?
The boat will almost certainly take an 8hp- however if you have accident the likelihood is that your insurance will be...
|
Forum: RIBs & ribbing
05 November 2013, 13:49
|
Replies: 18
Views: 3,756
Ian
Sorry about being a bit late to reply...
Ian
Sorry about being a bit late to reply to you on this one. As somebody noted above, there are a few RYA places in Hull. Also in your area look at Filey, who are always very active with...
|
Forum: Engines & props
05 November 2013, 13:43
|
Replies: 2
Views: 1,242
Conversion
Maxitope
The answer you had before is correct, however you can get it done more locally, which will save you a lot of travelling
Peter
|
Forum: Engines & props
05 November 2013, 13:29
|
Replies: 29
Views: 3,727
Trimix
The internet is not - unfortunately...
Trimix
The internet is not - unfortunately - the best place to look for this sort of answer.
Basically both Garmin 750 S and Suzuki DF175 are both NEMA compatible, and in very simple terms...
|
Forum: Engines & props
05 November 2013, 12:52
|
Replies: 42
Views: 26,496
Yes - definitely a good idea to disconnect the...
Yes - definitely a good idea to disconnect the fuel and let it run out on idle. Also a very good idea to take all your old fuel from the tank(s) and use it in the car or lawnmower in order to start...
|
Forum: Engines & props
04 November 2013, 15:23
|
Replies: 42
Views: 26,496
Max
We a have seen a large number issues...
Max
We a have seen a large number issues with engines like yours in the last two years -far more than we used to see in the past.
Your problem is almost certainly "gunging up" and...
|
Forum: RIBs wanted
14 October 2013, 09:16
|
Replies: 2
Views: 1,343
Tom
You would not necessarily need to have...
Tom
You would not necessarily need to have a repair shop with a template. The usual technique for us to copy a set of tubes is "make from scratch" a set of tubes is to make our own template by...
|
Forum: Engines & props
02 October 2013, 16:35
|
Replies: 9
Views: 3,448
Swesandy
Most likely to be a jammed or...
Swesandy
Most likely to be a jammed or malfunctioning thermostat. This should be opening when the engine has warmed up, and it sounds like it is jammed only partly open
Alternatively it might...
|
Forum: RIBs & ribbing
28 September 2013, 15:27
|
Replies: 6
Views: 1,424
Blannie
The standard Zodiac wheels (Zodiac...
Blannie
The standard Zodiac wheels (Zodiac accessories) are rated for this Zoom 350 boat and with the wheels on the boat it can be wheeled along with up to a 20hp engine. The transom is already...
|
Forum: Bits and pieces
21 May 2012, 07:33
|
Replies: 1
Views: 1,018
|
Forum: Bits and pieces
18 May 2012, 16:14
|
Replies: 3
Views: 1,290
Large outboard
nathan
Large Yamaha F225 outboard for sale in skipton
rergards Peter Bryson
|
Forum: Engines & props
18 May 2012, 16:06
|
Replies: 7
Views: 2,035
|