Forum: RIBs & ribbing
17 August 2016, 10:08
|
Replies: 13
Views: 2,009
Thanks John it has and still is a very reliable...
Thanks John it has and still is a very reliable and trusty engine, so I am pleased the respect is shared, just the manual start that was not a problem till I had a heart op.
If I change it will be...
|
Forum: RIBs & ribbing
16 August 2016, 20:47
|
Replies: 13
Views: 2,009
|
Forum: RIBs & ribbing
15 August 2016, 18:04
|
Replies: 13
Views: 2,009
|
Forum: RIBs & ribbing
15 August 2016, 14:16
|
Replies: 13
Views: 2,009
Avon SR4
I have an early 90's SR4 with a 40Hp ex RNLI Mariner (Yamaha). Its manual start and I am not getting any younger.
Has anyone updated one of these engines to electric start or if I go for an...
|
Forum: Engines & props
05 August 2013, 11:14
|
Replies: 6
Views: 2,140
|
Forum: Engines & props
05 August 2013, 10:57
|
Replies: 12
Views: 2,292
|
Forum: Engines & props
28 July 2013, 09:04
|
Replies: 12
Views: 2,292
sheard bolt on water pump
Festinghouse thanks or the advice but it is a bolt sheared off about 10mm below the surface, not a protruding stud, so I assume drilling with a stand drill to to ensure going vertical with the bolt...
|
Forum: Engines & props
27 July 2013, 10:21
|
Replies: 12
Views: 2,292
No I am not a welder, I am an electronics...
No I am not a welder, I am an electronics engineer, Ok with micro chips, but they come out with less effort (sometimes). I assume you warm up the alloy housing before attempting to remove the other...
|
Forum: Engines & props
26 July 2013, 20:51
|
Replies: 12
Views: 2,292
Hi jim it is one of the corner rear bolts, I...
Hi jim it is one of the corner rear bolts, I would go look, but the box is away having a skeg weld done. I removed it by removing what I suspect might be a short shaft to long shaft conversion which....
|
Forum: Engines & props
26 July 2013, 17:35
|
Replies: 12
Views: 2,292
1990 Mariner outboard
trouble getting to the water pump one bolt already sheared won’t take much to shear the others they are really tight
Should I try warming up the casting then removing the bolts ?
If and when...
|
Forum: Upcoming RIB cruises
08 July 2013, 19:50
|
Replies: 5
Views: 4,843
Lighting Coil ??
mine is a 40Hp Yamaha manual start, so no battery
The green wires have AC on them not DC
so the frequency of the AC will increase with revs
so does the voltage and it soon popped a small 12v...
|
Forum: RIBs & ribbing
29 April 2013, 10:14
|
Replies: 0
Views: 1,243
Mariner parts
My 4m Sea Rider has been gathering dust and I am determined to get it up an running this season
Alas i have removerd the gear change cable and put it very safe so I cannot find it. A cable should...
|