Forum: Inflatable boats - SIBs and folding RIBs
20 June 2012, 20:34
|
|
Replies: 10
Views: 10,618
West Mersea public slip is just East of the...
West Mersea public slip is just East of the hammerhead there and is good for 3ish hrs either side of HW. It gets very busy there in the summer and parking is difficult but not impossible. The slip...
|
|
Forum: Inflatable boats - SIBs and folding RIBs
20 January 2012, 19:24
|
|
Replies: 17
Views: 34,790
Hi meme
I have a T38ie for sale with a BF20....
Hi meme
I have a T38ie for sale with a BF20. Boat has been used only once (it was replaced new under warranty from Honda) and the engine only a year and a bit old. Comes with launch wheels, bow...
|
|
Forum: Inflatable boats - SIBs and folding RIBs
08 July 2011, 13:11
|
|
Replies: 11
Views: 5,395
I would leave them like they are. As the screws...
I would leave them like they are. As the screws are countersunk (they were in my t38) the contact area of the screw head will be very small if you reverse it. You could end up damaging the hole or...
|
|
Forum: Inflatable boats - SIBs and folding RIBs
05 June 2011, 15:57
|
|
Replies: 3
Views: 3,425
It's possible with a 20hp motor (I have the...
It's possible with a 20hp motor (I have the honwave setup) but it takes a while to get on the plane with heavier riders (I'm 14st an I sometimes have to 'bounce' up and down to gain momentum). Once...
|
|
Forum: Inflatable boats - SIBs and folding RIBs
29 March 2011, 12:29
|
|
Replies: 1
Views: 2,755
Honwave Pressure Gauge
Hi All
Has anyone tried to get a replacement pressure gauge for the one sold with the Honwaves? Mine had been dropped and I no longer trust the reading. This, coupled with the not so reliable...
|
