Originally Posted by mdt
that raised bit.... is infact 2 or 3 strips of marine ply. it is very very well stuck down. I would say it is not a small job to remove it. I used a chainsaw but i was not looking to keep the deck.
9inch grinder and keep a good grip on it best of luck.
use an electric planer ...cheap enough nowadys ....will give you a far better finish than a grinder and save you hours ...wear suitable protection and breathing safety wear though
if you do use a grinder use flexible sanding discs as grinding discs will leave unsightly gouge marks
been there and done it ...no big deal with a planer