Reply
 
Thread Tools Search this Thread
 
Old 24 June 2009, 22:14   #1
RIBnet supporter
 
tonymac's Avatar
 
Country: Ireland
Town: Belfast
Boat name: Cait
Make: Humber
Length: 5m +
Engine: 90hp Opti
Join Date: May 2007
Posts: 909
RIBase
Mooring Buoy

A friend of mine suggested that I set a mooring buoy in a small bay that I use for launching off the west of Ireland.

There are other buoys in the small inlet that is very sheltered.

I am thinking of doing this so that I do not have to launch and recover every day when I am there on holiday.

However --- I have no idea how to set a mooring buoy. Any help would be greatly appreciated.

Thanks
__________________
tonymac is offline   Reply With Quote
Old 24 June 2009, 22:25   #2
Member
 
m chappelow's Avatar
 
Country: UK - England
Town: yorkshire
Boat name: little vicky
Make: avon ex RNLI
Length: 3m +
Engine: tohatsu
Join Date: Mar 2008
Posts: 2,310
i suppose its how permanent your going to need it and how sheltered is it if the wind shifts ,some boats in our area use 3 danforth type anchors spead out on chains ie 12 oclock 4 oclock and 9 oclock positions then joining to a single riser chain on swivels to the surface bouy , though a lot depends on the type of sea bed ie rock mud ect..note if you use the traditional old type of anchor depending on depth at low water your boat could set down on a fluke and put a hole in your boat .
__________________
m chappelow is offline   Reply With Quote
Old 24 June 2009, 22:46   #3
RIBnet admin team
 
Poly's Avatar
 
Country: UK - Scotland
Boat name: imposter
Make: FunYak
Length: 3m +
Engine: Tohatsu 30HP
MMSI: 235089819
Join Date: Sep 2005
Posts: 11,622
What's the situation with doing this in Ireland? I think in the UK you would have to pay the Crown Estates Commission a fee (not sure if you "apply" up front or wait for them to come knocking).

I think the other problem is you need to be able to get the gear back up from time to time to inspect for corrosion/wear etc (your insurance will probably insist on this) unless it is a drying mooring - or maybe you can dive?
__________________
Poly is offline   Reply With Quote
Old 24 June 2009, 22:59   #4
RIBnet Supporter
 
willk's Avatar
 
Country: Ireland
Length: 4m +
Join Date: Feb 2008
Posts: 14,681
Quote:
Originally Posted by Polwart View Post
What's the situation with doing this in Ireland?
In harbours etc, there is usually someone at least co-ordinating this. In small bays and so forth, you rely on the co-operation of the locals. Take someone's traditional space and you'll be a long time looking for your boat . Tony will know this and sounds like he has it sussed already. (We're not big on rules as such - we prefer to think of them as guidelines. Arrrrr!)
__________________
willk is offline   Reply With Quote
Old 24 June 2009, 23:29   #5
Member
 
m chappelow's Avatar
 
Country: UK - England
Town: yorkshire
Boat name: little vicky
Make: avon ex RNLI
Length: 3m +
Engine: tohatsu
Join Date: Mar 2008
Posts: 2,310
Quote:
Originally Posted by willk View Post
In harbours etc, there is usually someone at least co-ordinating this. In small bays and so forth, you rely on the co-operation of the locals. Take someone's traditional space and you'll be a long time looking for your boat . Tony will know this and sounds like he has it sussed already. (We're not big on rules as such - we prefer to think of them as guidelines. Arrrrr!)
think that may have been on my mooring ....arrrrrr
Attached Thumbnails
Click image for larger version

Name:	4.jpg
Views:	353
Size:	44.2 KB
ID:	43535  
__________________
m chappelow is offline   Reply With Quote
Old 25 June 2009, 08:13   #6
RIBnet supporter
 
LURCHER's Avatar
 
Country: UK - England
Town: Lymington Hampshire
Boat name: Hot Lemon
Make: Scorpion
Length: 8m +
Engine: Yanmar diesel
MMSI: 235
Join Date: May 2002
Posts: 780
Mooring

Tony
I suggest you approach the locals who will probably offer you the use of an established one for a small fee or assist in setting your own . A tyre filled with concrete and the chain set in it was a mothod I used a long time ago .
__________________
www.hiremarquee.co.uk
LURCHER is offline   Reply With Quote
Old 25 June 2009, 09:34   #7
RIBnet Supporter
 
willk's Avatar
 
Country: Ireland
Length: 4m +
Join Date: Feb 2008
Posts: 14,681
Quote:
Originally Posted by LURCHER View Post
A tyre filled with concrete and the chain set in it was a mothod I used a long time ago .
This is certainly the preferred method in these parts. It does require a sandy, shaley or muddy bottom to work well - the mooring needs to bed in over a few tides to secure it properly - neither rubber nor concrete have any useful weight in water, so it's really the embedded whole that's holding the craft.
__________________
willk is offline   Reply With Quote
Old 26 June 2009, 07:47   #8
RIBnet supporter
 
tonymac's Avatar
 
Country: Ireland
Town: Belfast
Boat name: Cait
Make: Humber
Length: 5m +
Engine: 90hp Opti
Join Date: May 2007
Posts: 909
RIBase
Quote:
Originally Posted by willk View Post
This is certainly the preferred method in these parts. It does require a sandy, shaley or muddy bottom to work well - the mooring needs to bed in over a few tides to secure it properly - neither rubber nor concrete have any useful weight in water, so it's really the embedded whole that's holding the craft.


Thanks for all the advice folks. Its not a long term mooring that I'm after as I move my boat from Donegal to Belfast quite a bit. I'll take up the advice re the locals and perhaps a concrete filled tyre and chain. Many thanks folks
__________________
tonymac is offline   Reply With Quote
Old 26 June 2009, 09:06   #9
Member
 
Channel Ribs's Avatar
 
Country: UK - Channel Islands
Town: Alderney
Length: no boat
Join Date: Sep 2006
Posts: 3,047
Quote:
Originally Posted by tonymac View Post
Thanks for all the advice folks. Its not a long term mooring that I'm after as I move my boat from Donegal to Belfast quite a bit. I'll take up the advice re the locals and perhaps a concrete filled tyre and chain. Many thanks folks
If it is just a short term thing why not use a normal anchor? Rather than haul it every time, just put a buoy on the end.
__________________
Channel Ribs is offline   Reply With Quote
Old 26 June 2009, 11:23   #10
Member
 
Country: UK - England
Town: knebworth
Boat name: phoenix
Make: xs
Length: 6m +
Engine: 115 opti
Join Date: Jun 2005
Posts: 193
Send a message via MSN to mark-f Send a message via Skype™ to mark-f
re tempory anchoring

I do the same thing every year with my Rib and use a 12kg CQR on a mud/sand bottom and it even survived last year when we had a F8 storm over night.

The main thing is to follow all the normal rules about anchoring, make sure its the right type for the seabed, use all chain if possible and make sure you allow enough for the tidal rise and make sure the anchor is biting and check your transits and you should be ok.

As to if your insurance will cover you is a matter for you and your insurance company to agree

Mark
__________________
mark-f is offline   Reply With Quote
Old 26 June 2009, 18:40   #11
RIBnet Supporter
 
willk's Avatar
 
Country: Ireland
Length: 4m +
Join Date: Feb 2008
Posts: 14,681
Quote:
Originally Posted by malthouse View Post
If it is just a short term thing why not use a normal anchor? Rather than haul it every time, just put a buoy on the end.
'cos we're a bunch o' thievin' pikeys and it'd be gone faster than snow off a hedge!
__________________
willk is offline   Reply With Quote
Old 26 June 2009, 19:33   #12
Member
 
Bigmuz7's Avatar
 
Country: UK - Scotland
Town: Glasgow
Boat name: stramash
Make: Tornado
Length: 5m +
Engine: Etec 90
Join Date: Feb 2006
Posts: 5,090
Quote:
Originally Posted by willk View Post
Take someone's traditional space and you'll be a long time looking for your boat .

Quote:
Originally Posted by willk View Post
'cos we're a bunch o' thievin' pikeys and it'd be gone faster than snow off a hedge!
__________________
Bigmuz7 is offline   Reply With Quote
Old 26 June 2009, 20:25   #13
RIBnet Supporter
 
willk's Avatar
 
Country: Ireland
Length: 4m +
Join Date: Feb 2008
Posts: 14,681
What can I say? Aithníonn ciaróg ciaróg eile*

Knowledge of one's weaknesses is a kind of strength...
__________________________________________________ _

* One beetle knows another
__________________
willk is offline   Reply With Quote
Old 26 June 2009, 20:40   #14
Member
 
Bigmuz7's Avatar
 
Country: UK - Scotland
Town: Glasgow
Boat name: stramash
Make: Tornado
Length: 5m +
Engine: Etec 90
Join Date: Feb 2006
Posts: 5,090
Away and have a dram .. and let the odd 'in comer' have his day .. try Yamazaki 18yo as in my glass the now.. now that 'is' an in comer
__________________
Bigmuz7 is offline   Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off




All times are GMT. The time now is 18:42.


Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2024, vBulletin Solutions, Inc.