Avon 3.45 rib, 25hp yamaha?

[eliott]

Hi,
Im looking at buying a avon 3.45 sports rib and it does not have an engine.
I have a yamaha enduro 25 already, would it be powerful enough for it as i don't know what the maximum/minimum horse power is.
How many knots do could i get out of it?
Would i be able to tow a donut?
Thanks.

[hamster]

I've got one of these with a yamaha 9.9hp 4 stroke on it and it'll do 17 knots one up! I've got a single seat centre console in it with a 15l tank under the seat. Pull start so no battery on board

Sent from my iPhone using Rib.net

[Downhilldai]

S3.45 is rated to 30hp max. They take a longshaft motor, so check your 25 Yam is suitable.
You should be good for 28ish kts and it will be ok to tow a ringo.

[eliott]

is it definately longshaft? because i have a yamaha 25 longshaft, and i was told i would need a short shaft so i baught a new gearbox and they were going to convert it for me....
Just to check

[Downhilldai]

Yes, unless the transom's been chopped to take a std shaft motor.

Does it have red seats?

[eliott]

yes it does, do you know anything about it?

[Downhilldai]

Originally Posted by eliott

do you know anything about it?

I know it has a 20" transom:

[Downhilldai]

I've been tempted for a while to buy one of these, rip out the silly back to back seats, dashboard & 'bonnet', then fit a 3-cyl Soozook DT30 on a tiller.

I reckon it'd be a rite larf, being light as a feather with a bit of a vee in the hull.



The later S3.46 versions are rated to 40hp - now one of those would be tasty with a 3-cyl, 2-stroke Yam ......

[eliott]

so my longshaft yamaha would be ok for it?

i have seen some about without seats and dashboard.

[Downhilldai]

Originally Posted by eliott

so my longshaft yamaha would be ok for it?