Handles

in the bottom trailor, below the winch you can see two handles either side... where the hell can I get some that clamp on? to mine! Ive searched high and low and cant seem to find any anywhere!?

http://www.snipetrailers.com/prod4big.html
Cheers

Can you find someone to weld a bar on for you. A 5 minute job & much stronger than bolting on. I'd have a word with a few garages as a start - £20 and a bit of old 'scrap' tube and hey presto !

I think that one with two winches is for a couple of jetski's hence the need for two separate ones.

Might be wrong though!

in the bottom trailor, below the winch you can see two handles either side... where the hell can I get some that clamp on? to mine! Ive searched high and low and cant seem to find any anywhere!?

http://www.snipetrailers.com/prod4big.html
Cheers

The easiest way is to buy a new post. http://www.trailertek.com/cgi-bin/sh000001.pl?REFPAGE=http%3a%2f%2fwww.trailertek.co .uk%2facatalog%2fRoller_Assemblies.html&WD=post&PN=Miscellaneous_boat_trailer_fittings.html%23a1_2 1WIN135#a1_21WIN135

Hi, Its easy to make your own. 1"x16" long tube, a couple of handle bar grips and a standard trailer U bolt. The strenght is fine!!.

Dont get into welding your galv dipped trailer coz it will rust around any welds unless treated.:thumbs::thumbs:

Dont get into welding your galv dipped trailer coz it will rust around any welds unless treated.:thumbs::thumbs:

And give off some really nasty fumes while you do it.

Nasher

Snipe are now owned by Mersea Trailers in Colchester, Essex. Might be worth giving them a call - they did me a short drawbar version of an old Snipe design and using a very old design of winch post so it would all go in the garage..... I dealt with someone called Sarah.

They also sold me a "bolt on" mast step for my dinghy trailer, but that was when Snipe were independant and still in Brum.

I should also add the usual disclaimer that I'm nothing more than a happy customer......